Step 5 – Assemble the hand blender

shapanwwuom · Post by **shapanwwuom** » Mon Feb 17, 2025 5:58 am

From this point of view, a rotor with a small number of bars is preferable (for example, 16-il8 bars in the rotor on 24 stator slots). Starting conditions can be improved by increasing the resistance of the rotor cage (by turning the end closing rings), as well as by increasing the air gap by 10-20% (by grinding the rotor). Sometimes it helps to cut off several symmetrically located rotor bars. In cases where increased motor noise is tolerated, favorable results can be obtained with an odd number of rotor bars. All measures associated with increasing the resistance of the cells, of course, somewhat increase the nominal slip of the motor.

When using two-layer three-phase windings, reducing the step gives a positive effect! / with pole division. Data on asynchronous tripping of single-phase motors are given in the book: Yuferov F.

Once you have completed the necessary cleaning, inspection iraq telegram data and replacement of damaged parts, reassemble the parts from the motor housing to the blade shaft. Be sure to wipe down with a paper towel to remove any grease or debris from the outside before storing it.

Knowing how to perform simple repairs is essential to getting the most out of your hand blender in the kitchen. Learn to do it yourself and you'll find that it's not such a difficult task.

Finally got my BG LED TV repaired and I was very happy as I was able to earn money from this job. If you really want to get into LCD or LED TV, you can check out Kent's and Damon Ebooks. Once you get their ebooks, you can ask for their technical support to make you a good LCD/LED TV troubleshooter. All the best for you.

This article has been brought to you by Suranga Bandara, owner of an electronics repair shop in Anuradhapura, Sri Lanka.

Please show your support by clicking on the social media buttons below. Your feedback on the post is welcome. Please leave it in the comments. If you have any electronics repair articles you would like to share with us, please contact us HERE .