Page 1 of 1

Comfort Spot Infrared Heaters for Commercial, Residential and Industrial Applications

Posted: Sun Feb 16, 2025 10:46 am
by shapanwwuom
Gas leaks from the burner where the pilot light ignites the gas. If the burner is dirty, salty or blocked, the gas may not ignite immediately, causing unburned gas to accumulate until it reaches the pilot flame causing an explosion hazard.
A rooty and dirty burner and a yellow flame indicate this problem. After cleaning the burner and combustion chamber, the gas should burn blue with red and yellow parts.
Clean the burner

Spot heating locates the heater(s) over the areas you are in. Infrared japan telegram data heaters heat objects rather than air, so you will be warmer even in relatively cold weather. area. Some heaters use a quartz glass heating element. and some use a tubular element with a metal shell. Metal and panel heaters last longer, do not emit light, and are not susceptible to damage from environmental factors, shock, and impact. The advantage of quartz is that it heats up quickly (seconds) and produces higher infrared radiation efficiency.

Solaira ALPHA High Output Commercial & Industrial Quartz Infrared Heater for Outdoor or Indoor Use (1500, 2000, 3000, 4000, 4500 & 6000 Watts), Can Be Installed in Tandem Up to 18kW. 5000 Hours Emitter Life. IP23/65 Rated Rain & Snow Protection: Weatherproof Outdoor Housing. Tempered Safety Glass. 120 Volt: Power Cord Length: 15ft, Plug Included. 240 Volt: Power Cord Length: 6ft (Plug NOT Included; Direct Wiring Heater; Terminal Box Included) Fostoria Trimline Comfort Spot Heating Units with Quartz Tube Comfort Spot Heating Overhead "Spot" or "Zone" Heating Applications provide almost instant heat and can provide heat to specific areas within a large open area where a forced air heater would require more time and energy to heat.6' plug and cord. (120 and 240 Volts)
NUHEAT Tile and Stone Floor Heating System Simple Underfloor Heating is the solution for cold ceramic tile and natural stone floors. 120 or 240 volt mats. A thin installed mat of radiant electric heat, only 1/8 inch thick, directly between the tile and subfloor. Over 60 different standard mat sizes to fit most rooms, also available custom.